My Board

Seamless Textures for Adobe Photoshop CS

Tutorial by Josh`

This tutorial will teach you how to take a texture and make it seamless so you can tile them side to side and top to bottom without one single seam showing. Let\'s get started, shall we?

1.) Open up a texture that you wish to make seamless. I will be using this texture:

[img]http://www.killagraphix.com/tutorials/texture.gif[/img]

2.) Once opened up in PhotoShop, go to the Offset filter. ( Filter > Other > Offset... )


Use these settings:

[img]http://www.killagraphix.com/tutorials/1.gif[/img]

[img]http://www.killagraphix.com/tutorials/2.gif[/img]

3.) Click \"OK\", then get out your stamp tool. Hold down ALT and click right above one of the lines. Make sure your brush is bit \"fuzzy\" as I like to call it and go right over the lines. You will see that your image looks normal again like so:

[img]http://www.killagraphix.com/tutorials/3.gif[/img]

Tiled:

[img]http://www.killagraphix.com/tutorials/3.gif[/img][img]http://www.killagraphix.com/tutorials/3.gif[/img]
[img]http://www.killagraphix.com/tutorials/3.gif[/img][img]http://www.killagraphix.com/tutorials/3.gif[/img]